[WriteLog] ICOM addresses

[Ric Plummer]

Clive,
You didn't imagine it, it is there, or at least can be in
the rigs section. See mine below:

[rigs]
IcomForceSplit=1
Icom IC-756PRO=0x5c
Com5:=19200,n,8,1
Com7:=19200,n,8,1

It may be one of those things that isn't there unless you need it
and put it there.
The 0x  tells it it is Hex and the 5c is the address
As usual everything is case sensitive.
Hope that helps

Ric KV1W
 

-----Original Message-----
From: writelog-bounces at contesting.com
[mailto:writelog-bounces at contesting.com]On Behalf Of Clive Whelan
Sent: Wednesday, December 27, 2006 05:37
To: writelog at contesting.com
Subject: [WriteLog] ICOM addresses


I thought that the ICOM address ( if any) was somewhere in
the .ini file, and could be modified to override the
selection in the ports dialog. However I can't seem to find
it now. Did I imagine this, or is it perhaps the effect of a
surfeit of Xmas pudding?

73


Clive
GW3NJW

_______________________________________________
WriteLog mailing list
WriteLog at contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/