[WriteLog] Stuck in CW

[Mark Klocksin]

I just installed a parallel port keying interface.  When I open the  
CW-RTTYWrite window, my rig goes into transmit and stays there.  The  
keying works fine, but the rig is locked in xmt.  It stays in  
transmit even with the alt-k window set for "receive."

I have the M8 RigBlaster interfaced to my 756 Pro.  I just discovered  
the problem will go away if unplug the mic. from the rig, disabling  
the PTT.  Then the rig will do break-in keying.  But I'd rather use  
the PTT built into the RigBlaster to control the transmitter.

I've been using this system for some RTTY contests, so the PTT works  
properly in that mode.

Any tips appreciated.


TNX es 73, Mark WA9IVH