[WriteLog] correction - writelog across isolation transformers

[ve2lx]

  ----- Original Message ----- 
  From: ve2lx 
  To: witelog group 
  Sent: Monday, January 28, 2008 4:47 PM
  Subject: writelog across isolation transformers


  My writelog software now works on any mode RTTY CW SSB including macros.

  But I have a problem WITH SSB TX when I add insulation transformers (one on RX the other on TX ) in the computer audio output ( there is two transformers 1:1 at 600 / 900 ohms in a small box wired in parrallele with only two wires to the stereo connectors, one wire to the tip, the other to the ground side, and I respected the primary and secondary polarities ) ...? .

  I did'nt connect a secondary line side to a resistor or any other part as mentionned in articles ((( because it was working like that before, no more then two weeks ago when I decided to use shielded wires which was'nt before ( was smal lamp cable )

  ((( --- CORRECTION: In RTTY & CW I have RX & TX + audio --- ))) 
  ((( --- But in SSB I have a PTT on the rigblaster box but no audio from PC eared at RB (spkr) out connector so in ssb mode = no tx... ? --- )))

  Is there soemeone that an idea

  Gilles   ve2lx
  =============