[WriteLog] CW number setup

[Edward Taylor]

Hello to all,

I sent a email about a week ago asking about the CW display.  Gary, AL9A,  was kind enough to provide an answer.  Thanks Gary!

My new problem is this: when I set up the CW/RTTY/SSB Memory Setup window, I type in %3 so that my sequence will be sent in a three digit format.  The instructions in the WriteLog Manuals say that "T" will be sent for "0" (zero).  However, my program sends "0" NOT "T"  This makes a big difference in CW contesting.

The manual states that "if the mode is CW, the digits are translated to letters according to the [Cut-Numbers] section in WRITELOG.INI."  When I go to the [Cut-Number] instructions of the manual, it shows a table that says that 0 will be sent as 0 if "you don't set up this section."  The manual states that the WriteLog.ini file is in ASCII and is "directly editable."

I have not been able to discover how to set up the [Cut-Number] section of the WriteLog.ini file to send T for zero.  I haven't even been able to find the [Cut-Number] section in the .ini file.

Help? Anyone!

73,
Ed WB8TSD