[WriteLog] CW number setup

[VE3XD]

Ed,

The cut number section looks like this

[Cut-Numbers]
0=T
1=1
2=2
3=3
4=4
5=5
6=6
7=7
8=8
9=N

Mine follows the [Ports] section but that may not be critical.

73,
Don VE3XD 

> -----Original Message-----
> From: writelog-bounces at contesting.com 
> [mailto:writelog-bounces at contesting.com] On Behalf Of Edward Taylor
> Sent: September-23-09 7:47 AM
> To: WriteLog at contesting.com
> Subject: [WriteLog] CW number setup
> 
> Hello to all,
> 
> I sent a email about a week ago asking about the CW display.  
> Gary, AL9A,  was kind enough to provide an answer.  Thanks Gary!
> 
> My new problem is this: when I set up the CW/RTTY/SSB Memory 
> Setup window, I type in %3 so that my sequence will be sent 
> in a three digit format.  The instructions in the WriteLog 
> Manuals say that "T" will be sent for "0" (zero).  However, 
> my program sends "0" NOT "T"  This makes a big difference in 
> CW contesting.
> 
> The manual states that "if the mode is CW, the digits are 
> translated to letters according to the [Cut-Numbers] section 
> in WRITELOG.INI."  When I go to the [Cut-Number] instructions 
> of the manual, it shows a table that says that 0 will be sent 
> as 0 if "you don't set up this section."  The manual states 
> that the WriteLog.ini file is in ASCII and is "directly editable."
> 
> I have not been able to discover how to set up the 
> [Cut-Number] section of the WriteLog.ini file to send T for 
> zero.  I haven't even been able to find the [Cut-Number] 
> section in the .ini file.
> 
> Help? Anyone!
> 
> 73,
> Ed WB8TSD
> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/
>