[WriteLog] CW number setup

Alfred Frugoli ke1fo at arrl.net
Wed Sep 23 06:20:44 PDT 2009

And the section may not be in the writelog.ini file.  If that is the case,
you can add.  Just cut and paste the entire text from Don's e-mail into your
writelog.ini file, save the file then restart writelog.  Then the cut
numbers should work.

Good luck.

73 de Al, KE1FO

Check out my Amateur Radio Contesting blog at ke1fo.wordpress.com.

On Wed, Sep 23, 2009 at 7:46 AM, Edward Taylor <Phinehas at columbus.rr.com>wrote:

> Hello to all,
> I sent a email about a week ago asking about the CW display.  Gary, AL9A,
>  was kind enough to provide an answer.  Thanks Gary!
> My new problem is this: when I set up the CW/RTTY/SSB Memory Setup window,
> I type in %3 so that my sequence will be sent in a three digit format.  The
> instructions in the WriteLog Manuals say that "T" will be sent for "0"
> (zero).  However, my program sends "0" NOT "T"  This makes a big difference
> in CW contesting.
> The manual states that "if the mode is CW, the digits are translated to
> letters according to the [Cut-Numbers] section in WRITELOG.INI."  When I go
> to the [Cut-Number] instructions of the manual, it shows a table that says
> that 0 will be sent as 0 if "you don't set up this section."  The manual
> states that the WriteLog.ini file is in ASCII and is "directly editable."
> I have not been able to discover how to set up the [Cut-Number] section of
> the WriteLog.ini file to send T for zero.  I haven't even been able to find
> the [Cut-Number] section in the .ini file.
> Help? Anyone!
> 73,
> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/

More information about the WriteLog mailing list