[WriteLog] Correction: WriteLog + 75 Baud

[Joe Subich, W4TV]

Update for Writelog users:

The MMTTY plug-in sets its data rate and mode (RTTY/ASCII) when
it initializes.  Changes in RTTYrite are not reflected until
the plug-in is reinitialized.

To change RTTY mode, change the mode in the RTTYrite mode menu
then select the TU type.  You can even reselect MMTTY as that
will force a reload/reinitialization of the plug-in.

73,

    ... Joe, W4TV

On 6/6/2010 12:12 PM, Don Hill AA5AU wrote:
> WriteLog DOES transmit FSK and AFSK 75 Baud RTTY using the MMTTY
> plug-in for WriteLog.
>
> However, it doesn't work as you normally think it would.  In my
> testing, I brought up my normal RTTY setup using the MMTTY plug-in at
> 45 baud.  I then attempted to change the baud rate by going to the
> "Mode" menu in Rttyrite and selecting "75 baud (100 WPM) Baudot".
> When I transmitted, the rate remained at 45 baud.
>
> In order to change from 45 to 75 baud transmission, I had to go to
> the "Option" menu in the MMTTY RTTY Control panel and select
> "Setup(O)".  In Setup, I had to go to the Decode tab and change
> BaudRate to 75.
>
> I was then able to transmit 75 baud RTTY using WriteLog and the MMTTY
> plug-in to WriteLog.  This worked with my simple transistor FSK
> interface and my microHAM microKEYER.
>
> I working on a web page on this subject.  I will announce it when
> it's finished.
>
> 73, Don AA5AU http://www.aa5au.com http://www.rttycontesting.com
>
> _______________________________________________ WriteLog mailing
> list WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog WriteLog on the
> web:  http://www.writelog.com/
>