[WriteLog] 1000MP help

[Kostas Stamatis]

Mike I use a mark v and writelog.
I believe windows 7 is the same with other windows if you installed writelog 
outside programs directory and you made the installation as administrator.
Beside this you need a straight cable to connect your mp and computer's com 
or even better only pin 2 to pin 2, pin 3 to pin 3 and pin 5 to pin 5. Also 
you must setup writelog to see the right com port, as rig type choose yaesu 
ft-1kmp, baud rate 4800, poll is checked and comptt set to no.
Also in writelog.ini (becareful to change the right one as there are 2 in 
windows 7 installations - see previous posts)
under [RIGS] there is an entry
Com5:=4800,n,8,2

73 Kostas SV1DPI

----- Original Message ----- 
From: "Mike McIlheran K0MWM" <k0mwm at comcast.net>
To: <WriteLog at contesting.com>
Sent: Thursday, January 27, 2011 9:00 AM
Subject: [WriteLog] 1000MP help


>I am still looking for assistance in connecting my 1000MP to my laptop 
>running Windows 7 and WriteLog 10.83. Port 15 is the port it says it is 
>connected to. I went into Setup and put that radio into Port 15. But the 
>WriteLog window shows No Rig. Does the radio need to be programed as well? 
>Is there a link to a setup checklist? This is my third request for help!!
> Mike (K0MWM)
>
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/
>