[WriteLog] 1000MP help

[Tom Carrubba KA2D]

Mike

I think this is the solution
.... from WriteLog help files

WRITELOG.INI [Ports]
[Ports]

The COMn:= settings are used by the WriteLog Packet window and by the RTTY 
window. There are separate COMn: settings in the [RIGS] section used only 
for rigs.
COM1:=9800,n,8,1,
COM2:=4800,e,7,1,

There are 4 "slots" available for WriteLog rig interfacing. By default, 
CommSlot1 is COM1:, but you can change that by changing the number on the 
right of the equal sign.
These settings are not used for RTTY or for packet
CommSlot1=1
CommSlot2=2

In this example, the third and fourth slots are on COM7 and COM8. COM15 is 
as high as is supported.
CommSlot3=7
CommSlot4=8

So you would write
CommSlot 4=15 and check com4 in setup for your rig

Hope this helps
Tom KA2D

----- Original Message ----- 
From: "Mike McIlheran K0MWM" <k0mwm at comcast.net>
To: <WriteLog at contesting.com>
Sent: Thursday, January 27, 2011 2:00 AM
Subject: [WriteLog] 1000MP help


>I am still looking for assistance in connecting my 1000MP to my laptop 
>running Windows 7 and WriteLog 10.83. Port 15 is the port it says it is 
>connected to. I went into Setup and put that radio into Port 15. But the 
>WriteLog window shows No Rig. Does the radio need to be programed as well? 
>Is there a link to a setup checklist? This is my third request for help!!
> Mike (K0MWM)
>
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/