[WriteLog] Speed changes are lost when %I insertion variable is used in messages

[Mike Heideman]

We want to set up a QSY message that enables us to move stations to our mult radio in CQWW CW.  Since the mult radio is most likely tuned to a mult's frequency it doesn't make sense to use the %Z variable in the message.  Instead we opted to use %I and plan to quickly type in a frequency near the top of the band.

Instead of sending the QSY message at the normal run speed we want to slow it down to catch the attention of the operator that we're trying to move.  This also gives us a little more time to type in the frequency.  Here is a sample message that we tested, slowed down a lot so that we could easily tell the difference in speed.

OK 
  >>>>>PSE QSY %I<<<<<

This message sends OK at normal run speed, then sends PSE QSY much slower.  It then returns to the normal run speed to send the frequency that was typed in.  Is there a way to send the inserted keystrokes at the modified speed instead of returning to the original speed setting?  If not this would be a useful enhancement for situations such as the one described.

Our keying was done with a WinKeyer2.

-Mike, N7MH