[WriteLog] getting to work with icom pro 3

[Gary AL9A]

Scott,

Focus first on your MicroKeyer II and the router setup.  When you look at 
router does the micro KEYER II  tab show a green check mark, yellow X or a 
red X?  I suspect you have a green check mark since you are able to key CW 
the MKII is seeing com 5 and the WinKey chip is working.  On the Ports tab 
in router do you see your radio defined as IC-756ProIII?  Do you see the 
frequency display and mode of the radio on the Ports tab?  When you turn the 
VFO does the frequency display following along?  When you change modes does 
the mode indication follow along?  If not you probably don't have the Baud 
rate and/or the CI-V address in router set correctly to match the 
IC-756ProIII.

On the Ports tab click on the Set button to open the radio control setup 
page.  The Baud rate should be 9600 and the CI-V address set to 6E.  Leave 
the Port set to None.  With these settings do you now get radio tracking 
info in router?  If so go back to WL and if things are set correctly on the 
Setup/Ports tab there you should be good.

73,
Gary AL9A

----- Original Message ----- 
From: <W4so at aol.com>
To: <writelog at contesting.com>
Sent: April 18, 2012 2:56 AM
Subject: [WriteLog] getting to work with icom pro 3


> guys
> I am trying to figure out how to get the radio to display on the program.
> I upgraded my write log program to the most recent program a few days  ago
>
> I never had the computer able to display the radio's frequency.
> I am able to key the radio and send cw but that is the extent
>
> I am using the microham usb interface II and upgraded the most recent
> software on it as
> well
>
> I have the radio set on com 4 and cw set on com 5
>
> the radio is set for the following 6eh per the manaual
> baud rate 9600 , ci-v transceive on
> and ic731 off
>
> the program is set as I said the first line in the writelog program is set
> for com 4 , the radio is icom pro III
> and the second line is set for com 5 the cw.
>
> the settings in the microham virtual ports is set the same way as above .
> com 4 is radio and com 5 is cw
>
> what am I doing wrong?
>
> i can key the radio with the program and send cw , just not getting the
> freq display
>
> thanks
> scott w4so
> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/