[WriteLog] Band Map Problems

Gary AL9A al9a at mtaonline.net
Mon May 21 22:13:43 PDT 2012


When you say everything has been running pretty good, does that mean you 
used to get stuff in the band map or not?  You don't mention a DX cluster in 
your note.  Which cluster are you connecting to?  Are you using telnet? 
When you open the Incoming-only Packet window what does it say for a Telnet 
address and a Port number?  Need more info to figure out where the problem 
is.  Running V11.04A here and the Incoming-only Packet works FB - it should 
on your V11.02B too.

Gary AL9A

----- Original Message ----- 
From: "DickT-W0RAA" <dickt at w0raa.com>
To: "Writelog Reflector" <writelog at contesting.com>
Sent: May 21, 2012 5:54 PM
Subject: [WriteLog] Band Map Problems

> Hi guys,
> I'm running WriteLog 11.02B and up until recently, everything has been
> pretty good.  Well, during a recent contest, I brought up the Incoming 
> Only
> Packet Window, logged in, and was hoping to see some spots in the
> Bandmap window.
> Well, nothing appeared, and it still isn't working.  I'm not sure where to
> look
> next.  I usually operate non-assisted, but I wanted to see if there was 
> any
> DX or
> mutipliers that I could use.  I just can't get anything to appear in the
> Bandmap
> window.
> Can somebody (hopefully) point me in the right direction to see if I can
> start
> getting spots to show up in the Bandmap window.  Any assistance will be
> appreciated.
> 73,
> Dick - W0RAA
> w0raa[at]arrl.net
> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/ 

More information about the WriteLog mailing list