[WriteLog] WriteLog Digest, Vol 113, Issue 17

[DICK THOMPSON]

Hi Gary (and others)...

Yes, I used to get spots in the bandmap without a problem.  

I have normally used w0mu.net / port 23 which had worked fine.  I am using telnet and it says w0mu.net Port 23 (as above).  I have tried ve7cc and it's the same.  Outside of Writelog I am getting spots.  Using WriteLog I don't.  I can't figure out why, which is the frustrating part.  I use w0mu.net and ve7cc in my logging program (Win-EQF*) and the spots show up OK.  Everything else works in WL (CW/RTTY, SSB) with the exception of the spots.  I have even tried the command SET/NOFILTERS, and that doesn't help.  

I am using XP Home/SP3/Quad Core Processor and 3 gig of RAM.  

Hope that helps, Gary.  I appreciate the response from you.  HOPE TO SEE YOU IN THIS WEEKENDS WW WPX CW TEST.  I won't be able to spend a lot of time as we have to spend most of Saturday at a granddaughters high school graduation party.  So, it'll be a limited effort at this end.  

73,

Dick-W0RAA
Sent from my iPad 2  

PS:  The spots are appearing in the Incoming Only Packet Window in W0MU.net and VE7CC.  They are just not transferring to Writelog's Bandmap window.  I can furnish a screen shot of my layout if you think that would help any.  
__________________________________________________________

On May 22, 2012, at 1:00 PM, writelog-request at contesting.com wrote:

> Date: Mon, 21 May 2012 21:13:43 -0800
> From: "Gary AL9A" <al9a at mtaonline.net>
> Subject: Re: [WriteLog] Band Map Problems
> To: "Writelog Reflector" <writelog at contesting.com>
> Message-ID: <8360E277474D4C268492CCDCE9EF33A4 at AL9APC>
> Content-Type: text/plain; format=flowed; charset="iso-8859-1";
>    reply-type=original
> 
> Dick,
> 
> When you say everything has been running pretty good, does that mean you 
> used to get stuff in the band map or not?  You don't mention a DX cluster in 
> your note.  Which cluster are you connecting to?  Are you using telnet? 
> When you open the Incoming-only Packet window what does it say for a Telnet 
> address and a Port number?  Need more info to figure out where the problem 
> is.  Running V11.04A here and the Incoming-only Packet works FB - it should 
> on your V11.02B too.
> 
> 73,
> Gary AL9A