[WriteLog] How to setup Writelog for W1AW

[Steve AI9T]

Gary

I always pick DXpedition mode and down at the bottom is always shows 
General DX Tracking.

-- 
73

Steve AI9T

http://www.ai9t.com

AI9T DX Cluster

Version 4 AI9T   Telnet: dxc.ai9t.com port 7300
Version 6 AI9T-2 Telnet: dxc.ai9t.com port 7373 (CW + Skimmer)




On 5/28/2014 8:47 PM, Gary AL9A wrote:
> Ok, now I need a little help/advice.  Taking Jim's suggestion to heart 
> I've been trying to setup a new file for the upcoming W1AW/KL7 
> portable operation using the DXpedition module. My problem is every 
> time I start a new log and save it when I restart the log it comes up 
> in the DXCC tracking module rather than the DXpedition module.  I've 
> never seen this behavior before.
>
> As the young Air Force pilot appearing before an investigation board 
> following the crash of his aircraft stated, "Sir I ran out of 
> airspeed, altitude and ideas all at the same time."  Ditto here.  Any 
> suggestions?
>
> 73,
> Gary AL9A
>
> -----Original Message----- From: Jim Reisert AD1C
> Sent: May 23, 2014 12:20 PM
> To: Gary AL9A
> Cc: WriteLog
> Subject: Re: [WriteLog] How to setup Writelog for W1AW
>
> On Fri, May 23, 2014 at 10:23 AM, Gary AL9A <al9a at mtaonline.net> wrote:
>
>> Jim ADIC just asked essentially the same question recently.  The 
>> answer is
>> don't use the DXpedition module, but instead use the General DXCC 
>> tracking
>> log module.
>
> I guess it depends on what you want to do.
>
> If you are logging multiple modes on the same band using the same log
> file, you *want* DXpedition mode, not DXCC mode.  The reason being
> that DXCC mode dupes the stations once per band, whereas DXpedition
> mode dupes the stations once per band+mode.  What happened to me this
> morning is that all the guys who previously worked me on 30 RTTY were
> showing up as dupes on 30 CW.  The other way around is worse, because
> you can't use the INSERT key in RTTY on a "duplicate" call to capture
> it into the QSO window.
>
> You can still add the STATE field to the DXpedition module if you are
> inclined to logging the information that is sent to you.
>
> DXCC mode gives you multiplier stats for each band, regardless of
> mode.  DXpedition mode gives you multiplier stats regardless of band
> or mode, i.e. the first VK you work on any band counts as a multiplier
> for THAT band.  Since this isn't a contest, the reporting of
> multipliers is far less important than having dupes identified
> correctly.
>
> 73 - Jim AD1C
>