[WriteLog] Transmit problem with 2Tone/MMTTY

[Chad WE9V]

I had a similar problem after re-installing WL on a new hard drive before
ARRL RU.  I will describe my problem.  Maybe yours is similar.

I can't use XMMT.ocx for MMTTY, because I have a large PTT to audio delay
on starting TX, and a long PTT "tail" after the audio tones are done.  No
one has been able to help me with this.  So I must use the MMTTY plug-in.
I get MMTTY all set up fine.  TX is fine.

Next I clone (RX only) that rttyrite window, choose xmmt.ocx and then
2Tone.  That's running and decoding...but now I have no TX audio.
I check the MMTTY settings for soundcard...all is perfect.
I check the 2Tone settings, and the TX is selecting a different audio
path.  I wouldn't think this matters, because in this example, 2Tone is the
Cloned RX, and should only be used for RX.  Wrong.  If I change the 2Tone
TX to the correct audio path, then I get TX back.  This completely implies
that 2Tone is being used for TX generation, even though it's only supposed
to be a Clone (RX only).

Puzzling.

Chad WE9V

On Tue, Jan 13, 2015 at 8:17 PM, Jim Brown <jim at audiosystemsgroup.com>
wrote:

> On Tue,1/13/2015 5:11 PM, joeduerbusch wrote:
>
>> What I did for rtty was to set mmtty for lowtones, 1445
>>
>
> I use 915 Hz because it's easier for my ear to tune it in.
>
> 73, Jim K9YC
>
> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/
>