[WriteLog] Digirite and IC-7300 / VFO and USB-D issue

[Don Hill AA5AU]

Someone else had this same problem but no solution was given. You can try manual entry - press the frequency button on the left of the entry window and use the pull-down menu to select manual entry, then type in the frequency. That might work.

Don AA5AU

-----Original Message-----
From: WriteLog [mailto:writelog-bounces at contesting.com] On Behalf Of I2SVA - Alessandro
Sent: Saturday, August 31, 2019 12:10 PM
To: writelog at contesting.com
Subject: [WriteLog] Digirite and IC-7300 / VFO and USB-D issue

Hi all,

 

I am trying to set up Digirite (1.1.23) and Writelog (12.42G) with Icom IC-7300.

The IC-7300 must be set to USB-D mode when using FT4/8.

My issue is that when Digirite moves to TX it always switch the rig (IC-7300) from USB-D to USB, even if the File|Setup check-box “Always force rig to USB mode “ is NOT checked (as a matter of fact there is no difference if the box is checked or not). The only way to avoid the issue is to check “NO VFO CONTROL” but this is not a good solution.

Any help?

 

Thanks, 73

Alessandro, i2sva

 

 

_______________________________________________
WriteLog mailing list
WriteLog at contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/