[WriteLog] Running on Writelog

[Rich Newbould]

Not sure what benefit RUN and S&P provides in N1MM, I am sure somebody 
does, but means nothing to me.

I just use my macro key assignments to dictate RUN and S&P.

F2-F3- F4 for RUN

F5 - F6 for S&P

Yes you can setup ENTER Sends Exchange in WL.  Just assign the proper 
Macro Key assignments in your WL.ini file

Example of mine:

Put these with the F key assignments of your liking in the 
[Configuration] section

SendCallExchangeKey=3
QrzFunctionKey=4
CqFunctionKey=2

Note: I prefer to use the F1 as my "AGN" or "?" key.   So F2 is my CQ, 
F3 Exchange, F4 QRZ





On 4/6/2026 2:59 PM, Mark Griffin wrote:
> Normally with N1MM you can designate whether you wish to run or use S&P. Of
> course when running you normally hit the enter key and your transceiver
> calls CQ. When someone responds to your CQ you enter their callsign and hit
> enter and your transceiver sends the exchange. Once that is done they give
> you their exchange and you hit enter and your transceiver sends TU and QRZ.
> And then the process of calling CQ starts all over again. I see that there
> are S&P memories, but don't see anything specific with regards to running.
> Can anyone assist me with this?
> Mark Griffin, KB3Z
> _______________________________________________
> WriteLog mailing list
> WriteLog at contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web:  http://www.writelog.com/