[Yaesu] FT-101E rcv-xmt offset?

[Wiley Sanders]

This is an alignment issue. There are two trimmer pots that control the 
offset, one that controls the offset with the Clarifier off, and another that 
further controls it with the Clarifier on, to set the zero point. The 
procedure is in the manual, although the English translation is a little 
vague. The schematic will show how (these are VCOs). If you are not 
experienced at alignment, don't worry about it and just leave the clarifier on 
all the time. That's what I do, and I've attached a small adhesive marker to 
show the zero point. Call CQ and after a few QSOs you will find the spot. (Its 
out of the CW passband on my rig. No wonder nobody came back to my first few CQs!)

-Wiley KF6IIU