[Yaesu] FT-101E rcv-xmt offset?

[Steve Lawrence]

I had a 101E many years ago. It an TX offset problem that was very 
elusive. Stations would not come back to me when I was zero beat with 
the last Q (or so I thought). The problem was finally traced to a dirty 
contact in the T/R relay.

73, Steve WB6RSE

On Thursday, January 23, 2003, at 08:25  AM, Wiley Sanders wrote:

> This is an alignment issue. There are two trimmer pots that control 
> the offset, one that controls the offset with the Clarifier off, and 
> another that further controls it with the Clarifier on, to set the 
> zero point. The procedure is in the manual, although the English 
> translation is a little vague. The schematic will show how (these are 
> VCOs). If you are not experienced at alignment, don't worry about it 
> and just leave the clarifier on all the time. That's what I do, and 
> I've attached a small adhesive marker to show the zero point. Call CQ 
> and after a few QSOs you will find the spot. (Its out of the CW 
> passband on my rig. No wonder nobody came back to my first few CQs!)
>
> -Wiley KF6IIU
>
> _______________________________________________
> Yaesu mailing list
> Yaesu at contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
>