[Yaesu] Yaesu Digest, Vol 81, Issue 6 - translated

kq6i at arrl.net kq6i at arrl.net
Sun Sep 13 15:05:17 PDT 2009

 the yaesu gentlemen I am interested in obtaining a yaesu line diagrams but but may I them estare typing when I needed to
say that when a colleague bring me your radio to repair I keep the diagramo or manual thank estare in contact with you.
Carlos peña (j) adolfo

-----Original Message-----
From: Carlos Adolfo Peña [mailto:carlosadolfopjm at hotmail.com] 
Sent: Sunday, September 13, 2009 3:16 PM
To: c......yaesu
Subject: Re: [Yaesu] Yaesu Digest, Vol 81, Issue 6

señores de la yaesu estoy interesado en obtener unos diagramas de la linea yaesu pero sino es posible yo les estare
escribiendo cuando yo los necesite quiero decir que cuando un colega me traiga su radio para reparar yo tenga el diagramo o
manual muchas gracias estare en contacto con ustedes.

carlos adolfo peña j

colombia s.a

> From: yaesu-request at contesting.com
> Subject: Yaesu Digest, Vol 81, Issue 6
> To: yaesu at contesting.com
> Date: Sun, 13 Sep 2009 12:00:42 -0700
> Send Yaesu mailing list submissions to
> yaesu at contesting.com
> To subscribe or unsubscribe via the World Wide Web, visit
> http://lists.contesting.com/mailman/listinfo/yaesu
> or, via email, send a message with subject or body 'help' to
> yaesu-request at contesting.com
> You can reach the person managing the list at
> yaesu-owner at contesting.com
> When replying, please edit your Subject line so it is more specific
> than "Re: Contents of Yaesu digest..."
> Today's Topics:
> 1. G-1000 DXA calibration (Mike)
> ----------------------------------------------------------------------
> Message: 1
> Date: Sat, 12 Sep 2009 18:57:33 -0400
> From: Mike <nf4l_NO_SPAM at nf4l.com>
> Subject: [Yaesu] G-1000 DXA calibration
> To: Yaesu Reflector <yaesu at contesting.com>
> Message-ID: <4AAC275D.70303 at nf4l.com>
> Content-Type: text/plain; charset=ISO-8859-1; format=flowed
> On page 8 of the manual, in item 7, there is mention of two raised 
> calibration marks. My rotor has three, the one on the base and two on 
> the rotating bell. The two on the rotating bell are roughly 90 degrees 
> apart. One is above the mold mark (or separation) and one is below.
> Which one is the correct one to use for the alignment procedure? Neither 
> is aligned with the mark on the base.
> 73, Mike NF4L
> ------------------------------
> _______________________________________________
> Yaesu mailing list
> Yaesu at contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
> End of Yaesu Digest, Vol 81, Issue 6
> ************************************

Explore the seven wonders of the world
Yaesu mailing list
Yaesu at contesting.com

More information about the Yaesu mailing list