[Top] [All Lists]

[Fwd: [AMPS] Edge wound .1-40 uH Variable from SSN - comments-?]

To: <>
Subject: [Fwd: [AMPS] Edge wound .1-40 uH Variable from SSN - comments-?]
From: (Rich Measures)
Date: Fri, 12 Feb 1999 19:57:26 -0800

>I saw the "jig" that is used to roll the coil in the Nye Viking MB V A, at
>the factory in north Idaho. Hard to explain, but really works neat!!   Just
>some wheels and rollers.....hooked to a lathe at very slow speed.....
>BTW Rich and Carl, What do you think of the idea that Henry uses for there
>tanks in some of there amps. ??
?   If C-tune is the right value, variable L works well.  

>Having a fixed value of C tune, and a roller coil for the "plate tuning"
>..It uses a Pi-L and a standard loading cap.   There is no C tune used on 10
>and 15 meters. Just the tube and stray capacitance. The amps put out a good
>1500 watts on 10 and 15 meters both......(2kd5)....They use "door knobs" for
>the tune caps. Using a neat switching arrangement for selecting them......
>Besides the high filament voltage and the low value of R across the
>electrolytic caps, the amp works great....
>Comments please...
>What is the current through the door knob caps ?
?   It is basically I=E/ohms of reactance.  E is  approx 90% of the 
supply potential x 0.707.  
-  later, Jim


R. L. Measures, 805-386-3734, AG6K,  

FAQ on WWW:     
Administrative requests:

<Prev in Thread] Current Thread [Next in Thread>