Amps
[Top] [All Lists]

[AMPS] Testing HV Psu

To: <amps@contesting.com>
Subject: [AMPS] Testing HV Psu
From: rfamps@ic24.net (Steve Thompson)
Date: Tue, 29 Aug 2000 08:40:14 +0100

-----Original Message-----
From: Steve Eldridge <steve@g8izy.freeserve.co.uk>
To: amps@contesting.com <amps@contesting.com>
To: <amps@contesting.com>
Date: 28 August 2000 21:40
Subject: [AMPS] Testing HV Psu


>
>Hello All,
>
>I am nearing completion of a new HV psu. This time, I am doing the job
>properly with due regard to safety and reliability.
>
>My question is : Is there a "tried and trusted" way of  introducing a
>dead short-circuit across the supply, preferably repeatedly- apart from
>shorting with the proverbial screwdriver!
>
>I am considering making a well insulated "knife switch", with the earthy
>side to the handle (and the hinge supplemented with copper braid) behind
>a clear plastic screen. Unless there are some better suggestions....?


Plastic tweezers, rubber gloves and goggles perhaps?

Somewhere on their site, Svetlana recommend a size and length of wire which
should not burn out in such a test for a 800/1500W valve.

Steve


--
FAQ on WWW:               http://www.contesting.com/FAQ/amps
Submissions:              amps@contesting.com
Administrative requests:  amps-REQUEST@contesting.com
Problems:                 owner-amps@contesting.com


<Prev in Thread] Current Thread [Next in Thread>