On Apr 10, 2006, at 7:19 AM, Bill Turner wrote:
> ORIGINAL MESSAGE:
>
> At 06:07 AM 4/10/2006, R@contesting.com;Measures wrote:
>
>> A factor of 1.8 is close enough. The exact factor is dependent on
>> ZSAC, so there is no magic number written in stone.
>
> *********** REPLY SEPARATOR ***********
>
> Correct me if I'm wrong, but isn't the factor - 1.8 or whatever -
> only a starting point to get the design close to the desired Q?
Q is set by the builder. RL divided by Q approximately determines XC1.
> As I
> understand it, if you get the number a little bit "wrong", the only
> effect is to shift the final Q slightly. Is this correct?
>
> 73, Bill W6WRT
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
Rich Measures, 805.386.3734, AG6K, www.somis.org
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|