On Jul 24, 2006, at 9:03 PM, Will Matney wrote:
> Keith,
>
> Excessive grid current did, either from being over driven, or an
> arc from a gassy tube.
Will M.: Could an unloaded condition cause excessive grid current?
>
> Best,
>
> Will
>
> *********** REPLY SEPARATOR ***********
>
> On 7/24/06 at 10:28 PM Keith Dutson wrote:
>
>> I am not talking about AFTER the fuse blows. What current CAUSED
>> it to
>> blow?
>>
>> Thanks.
>>
>> Keith
>>
>> -----Original Message-----
>> From: amps-bounces@contesting.com [mailto:amps-
>> bounces@contesting.com] On
>> Behalf Of Will Matney
>> Sent: Monday, July 24, 2006 9:33 PM
>> To: amps@contesting.com
>> Subject: Re: [Amps] "Tubes 201" - How Vacuum Tubes Really Work
>>
>> Keith,
>>
>> Since it's loose from ground, and no corcuit can be made, it hangs in
>> space,
>> and can only be acted upon by the electron flow from the cathode.
>> In this
>> case, if the grid is slightly more positive, it will accept some
>> electrons
>> thus bringing it to 0 volts or slightly negative to ground. This
>> is called
>> coming into equilibrium or equalling out. If the tube is not slightly
>> positive, it will not accept any electrons, and the electron flow
>> will be
>> opposed by the grid. Terman, and I think the author of Tubes 201
>> discuss
>> this. In any case, the grid can never be made positive by these
>> actions
>> taking place.
>>
>> Earlier, when Rich mentioned about grids, I thought he meant a grid
>> becoming
>> positive. Bill posted what he meant which is correct and the same
>> as above.
>> I privately told Rich of this, and am sorry I questioned him, it
>> was a
>> mis-understanding. We actually were meaning the same thing at the
>> time.
>> Rich
>> like me does not believe a grid can become positive by being
>> bombarded by
>> electrons. Even if a grid gets to the point of emitting electrons
>> from
>> being
>> hot, they are replaced by the electron flow from the cathode. By
>> reading
>> some other texts, none of those do either.
>>
>> Best,
>>
>> Will
>>
>> *********** REPLY SEPARATOR ***********
>>
>> On 7/24/06 at 9:15 PM Keith Dutson wrote:
>>
>>> I am totally lost on this excessive grid current discussion. If
>>> there
>>> is a resistor or fuse tied between the grid and chassis and it
>>> blows,
>>> the grid obviously has a potential above or below ground. Which
>>> is it?
>>> Can it be either depending on the fault?
>>>
>>> 73, Keith NM5G
>> [snip]
>>
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>
>
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
R L MEASURES, AG6K. 805-386-3734
r@somis.org
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|