Amps
[Top] [All Lists]

Re: [Amps] Help with ARRL handbook design 4CX1000A 2m PA

To: amps@contesting.com
Subject: Re: [Amps] Help with ARRL handbook design 4CX1000A 2m PA
From: Paul Kelley N1BUG <paul.kelley.n1bug@gmail.com>
Date: Mon, 21 Jul 2008 20:29:45 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
I think there must be some problem unique to your specific 
amplifier. I built and used that amp for several years with good 
results, efficiency close to 60%. I have read your subsequent 
responses to other replies. How hard are you driving it? What is the 
plate current with drive and how much output are you seeing?

Paul N1BUG


Pete Lindsay wrote:
> Hi Guys,
> 
> I have a 2m PA built around the design in the 1986 ARRL handbook
> chapter 31 using a 4CX1000A. It was built by a friend to a very high
> spec and looks like an exact copy of the original design. The problem
> is it has never really worked that well. The problem lies in the
> output efficiency which, at best, is only around 30-35%. I am using
> 3KV on the anode and have tried several tubes. The screen grid and
> control grid currents act as you would expect when
> increasing/decreasing the loading, but the output is just not there
> (measured on several different power meters). I would be very
> interested if anyone out there has successfully built one of these
> amps and managed to get a reasonable output efficiency. Other amps I
> have built with 8877/GS35 etc all work fine, but this one has me beat.
> Is there a critical part to the design which needs close attention to
> get it to work? Any help appreciated!
> 
> Thanks
> 
> 
> Pete, G4CLA.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>