In the old days of Class C and early SSB a 10X reactance was the norm
for the choke.
As bands were added (15M took out the National R-175 for example and
resulted in the R-175A) and since the late 60's the reactance went down
to the 3-5X range. In those cases the choke actually becomes part of the
tank circuit. You cant go by the calculated reactance either as
distributed and stray C changes things in the real world. Sweep any of
the modern chokes and you will see how close to smoke many are on a band
or three.
You then wind up with having to install sufficient C as the choke bypass
as electrolytics really object to RF. Hang a HV scope probe on some so
called well designed amps and take a look. And then understand why those
brands are notorious for premature filter failures.
I suggest a pair of .0047's or a .01 as the choke bypass, Then a
vitreous enamel WW glitch resistor and another .01 to be sure of a clean
HV. The resistor uses nichrome wire which has its own L and acts as a
secondary choke to any funny stuff that gets by L-1.
Mouser carries Vishay 6KV discs as well as the resistors at very
reasonable prices.
Carl
KM1H
----- Original Message -----
From: "Eddy Swynar" <gswynar@durham.net>
To: <amps@contesting.com>
Sent: Thursday, February 05, 2009 7:35 AM
Subject: [Amps] Plate Choke Values
> Good Morning All,
>
> Am I missing something here...?
>
> Extensive research here into years & years of ARRL HANDBOOKS, Bill Orr
> HANDBOOKS, and the internet have shed precious little light in the
> matter of optimum / minimum values of inductance for plate chokes in
> the B+ leads of our tube-type linear amplifiers.
>
> Have a look-see yourself: in designs that feature amplifiers that only
> go as low as 3.5-MHz, you'll see chokes that range in value anywhere &
> everywhere from 200-uh, to 50-uh. On 160-meters, I've seen quoted
> values as high as 1.0-mh., and others as low as 200-uh.
>
> Just what, exactly, is a "...minimum reactance" for a choke, on a
> given frequency band, to do its job effectively, anyway...?
>
> I know confusion can creep in in the form of the self-destruction of
> these parts if the hapless home brewer happens upon a band where
> there's self-resonance in the choke...but that issue aside, is this
> all some matter of "...by gosh & by golly black magic", or are there
> very real minimum standards & parameters that we should adhere to...?
> And if so, where are said standards published...?
>
> I certainly can't find them via "...the usual" routes --- but again, I
> must be missing something here...
>
> ~73~ Eddy VE3CUI - VE3XZ
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|