Amps
[Top] [All Lists]

Re: [Amps] Solid state relays and step start

To: <sub1@rogerhalstead.com>
Subject: Re: [Amps] Solid state relays and step start
From: Mike Saculla <fqm@msn.com>
Date: Fri, 5 Mar 2010 18:55:51 -0800
List-post: <amps@contesting.com">mailto:amps@contesting.com>
Roger, your last line tells the story. If it fails shorted, it should be 
obvious by the fact that the equipment won't shut off. But a failure at some 
resistance would certainly set up a potential dangerous situation. I've only 
seen the shorted situation, but you have a lot more experience than I with 
SSRs. This is important info for those that use or want to use SSRs in their 
amps. Thanks!

Mike K6MDS


> Date: Fri, 5 Mar 2010 02:29:04 -0500
> From: sub1@rogerhalstead.com
> To: fqm@msn.com
> CC: amps@contesting.com
> Subject: Re: [Amps] Solid state relays and step start
> 
> Many years of working with the things I agree ... mostly.  Although they 
> normally fail shorted, they do occasionally fail "leaky" in a mode from 
> low to high resistance, but rarely open. Not never, but rarely.
> So, it's bad enough to have them fail shorted, but then a small 
> percentage will leave you guessing.
> If they fail other than shorted and under load it can get real smelly in 
> there.  OTOH they can fail with enough resistance that the circuit won't 
> work, but is quite capable of electrocuting you.
> 
> 73
> 
> Roger (K8RI)
> 
> Mike Saculla wrote:
> > When solid state relays fail, they fail in the shorted condition. One of 
> > their downfalls.
> >
> > Mike K6MDS
> >
> >
> > From: garyschafer@comcast.net
> > To: Amps@contesting.com
> > Date: Thu, 4 Mar 2010 15:53:17 -0500
> > Subject: [Amps] Solid state relays and step start
> >
> > Has anyone had problems using a solid state relay to short out the step
> > start resistor in a power supply?
> >  
> > I have heard of problems of not enough current thru the SS relays (when amp
> > is in standby) when used as the primary on/off relay. Sometimes a resistor
> > has to be placed in parallel with the transformer primary so the relay works
> > properly.
> >  
> > When used in a step start circuit the current could be quite low as well as
> > the voltage at the relay due to the resistor across the relay.  Any issues
> > here?
> >  
> > 73
> > Gary  K4FMX                                           
> > _______________________________________________
> > Amps mailing list
> > Amps@contesting.com
> > http://lists.contesting.com/mailman/listinfo/amps
> >
> >   
                                          
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>