On 9/19/10 12:19 PM, Randy S. wrote:
> Hi again,
> Powered up the amp .. filaments light .. blower works .. timer circuits
> for
> HV and Blower work.
> Having trouble tuning it ..
> Vacuum caps for plate and loading.
> Have loading cap at minimum. Evidenced by the plates in the vacuum cap moving
> away from each other.
Did you move the load cap?
Put radio on cw, 50 watts out, send 20wpm dots and tune for max out using both
caps.
With cw dots you are "pulse" tuning at 30% duty.
Reverse design it. Measure the coil and tap placement, the caps should be
marked
with values or part number. (USC500). Look up cap specs. Use the counter dials
to figure cap value per band and look at charts in handbook for a semi guess
setting for each band.
--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.
_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
|