Amps
[Top] [All Lists]

Re: [Amps] Supply question

To: "Sam Carpenter" <sam@owenscommunication.com>, "'Rob Atkinson'" <ranchorobbo@gmail.com>, <amps@contesting.com>
Subject: Re: [Amps] Supply question
From: "Carl" <km1h@jeremy.mv.com>
Date: Wed, 20 Jul 2011 11:58:32 -0400
List-post: <amps@contesting.com">mailto:amps@contesting.com>
----- Original Message ----- 
From: "Sam Carpenter" <sam@owenscommunication.com>
To: "'Rob Atkinson'" <ranchorobbo@gmail.com>; <amps@contesting.com>
Sent: Wednesday, July 20, 2011 11:41 AM
Subject: Re: [Amps] Supply question


> When you run the 3-500 easy, you will have a greater chance of arcs than 
> if
> you run the cherry red or orange. The gettering material is on the anode 
> and
> it requires color, sometimes significant color, to eat up the full range 
> of
> gas. I would venture to say that you may have less chance of arcing in a
> higher voltage amp that is used regularly.
>
> -----Original Message-----
> From: amps-bounces@contesting.com [mailto:amps-bounces@contesting.com] On
> Behalf Of Rob Atkinson
> Sent: Wednesday, July 20, 2011 11:16 AM
> To: amps@contesting.com
> Subject: Re: [Amps] Supply question
>
> I understand that with 3-500 the 3rd order IMD gets pretty lousy when
> the Ep gets up there much above 3 KV.


Read the spec sheet.


>
> I also had some idea you get a much bigger chance of arcs in the tube
> if you push the Ep way up there near the limit.


Very true when gas is involved as the voltage needed to ignite is in inverse 
proportion. A 4000V amp still outgasses when not regularly used and is more 
prone to arc when turned on.

OTOH Chinese tubes may not even hi-pot at 7000V which is why Ameritron 
rejects so many since they could arc on a normal voice peak. I believe they 
test to 9 or 10KV. Even a little bit of gas will ignite an arc when the 
threshold is low.
A good Eimac used to hi pot above 12KV when new since they were rated for 
Class C AM at 3KV.

Personally I would never run any unknown tube without a hi pot first and if 
necessary a full gettering at around 1000V

Carl
KM1H

.>
> comments?
>
> 73
>
> Rob
> K5UJ
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
> _______________________________________________
> Amps mailing list
> Amps@contesting.com
> http://lists.contesting.com/mailman/listinfo/amps
>
>
> -----
> No virus found in this message.
> Checked by AVG - www.avg.com
> Version: 10.0.1390 / Virus Database: 1518/3776 - Release Date: 07/20/11
> 

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps

<Prev in Thread] Current Thread [Next in Thread>