Amps
[Top] [All Lists]

Re: [Amps] HIGH FILAMENT VOLTAGE

To: "'amps'" <amps@contesting.com>
Subject: Re: [Amps] HIGH FILAMENT VOLTAGE
From: "Jim Hargrave" <w5ifp@gvtc.com>
Date: Sat, 10 Dec 2016 22:38:25 -0600
List-post: <amps@contesting.com">mailto:amps@contesting.com>
You can reduce the voltage with parallel back to back diodes in series with 
each tube filament.
20 amp/40v diodes are cheap and do not present a mounting challenge.

73, Jim – w5ifp@gvtc.com

>> -----Original Message-----
>> From: Amps [mailto:amps-bounces@contesting.com] On Behalf Of
>> w8hw@comcast.net
>> Sent: Saturday, December 10, 2016 6:41 PM
>> To: Mike Waters <mikewate@gmail.com>; amps@contesting.com
>> Subject: Re: [Amps] HIGH FILAMENT VOLTAGE
>> 
>> Mike is correct. I have used 27 inch of #18 wire on 3-500 tubes many
>> times and got voltage down to 4.97 volts for each tube. The wire is
>> just one big resistor and gets warm, but works fine. The life of 3-500
>> drops real fast with high filament voltage.
>> 
>> 73, Bruce, W8HW
>> ========================
>> 
>> -----Original Message-----
>> From: Mike Waters
>> Sent: Saturday, December 10, 2016 19:15
>> To: amps@contesting.com
>> Subject: Re: [Amps] HIGH FILAMENT VOLTAGE
>> 
>> No need to use #12. Smaller wire = more compact. A shorter piece
>> of #16 (or maybe even #18), would do fine.
>> 
>> Depends on the current.
>> 
>> 73, Mike
>> www.w0btu.com
>> 
>> On Sat, Dec 10, 2016 at 5:58 PM, kenneth Johnson
>> <wa6rtp@hotmail.com> wrote:
>> 
>> > I used # 12 wire …total of 24 inches long  wound in a two inch coil
>> > placed in each filament lead .
>> > this  droped  the voltage on my henry 2k-3  filaments into
>> specifation.
>> > your problem is finding enough room to get the coil in there.  at
>> any
>> > rate …a length of wire is the way to go.
>> >
>> >
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps
>> 
>> _______________________________________________
>> Amps mailing list
>> Amps@contesting.com
>> http://lists.contesting.com/mailman/listinfo/amps

_______________________________________________
Amps mailing list
Amps@contesting.com
http://lists.contesting.com/mailman/listinfo/amps
<Prev in Thread] Current Thread [Next in Thread>