I generally advise against the technique. In some cases, what is loose on the
pole can come down. It would not be very productive to diagnose the problem by
dropping the bad insulator through the windshield of the passing car... or on
your own head if you care more about that! :-)
Ed Hare, W1RFI
ARRL Laboratory Manager
225 Main St
Newington, CT 06013
Tel: 860-594-0318
Internet: W1RFI@arrl.org
Web: http://www.arrl.org/tis
Member: ASC C63 EMC Committee
Chairman: Subcommittee 5, Immunity
Chairman: Ad hoc BPL Working Group
Member: IEEE SCC-28 RF Safety
Member: Society of Automotive Engineers EMC/EMR Committee
Member: IEEE
> -----Original Message-----
> From: rfi-bounces@contesting.com [mailto:rfi-bounces@contesting.com]On
> Behalf Of Tom Rauch
> Sent: Monday, July 19, 2004 4:53 PM
> To: Ward Silver; rfi@contesting.com; Pete Smith
> Subject: Re: [RFI] Pin Arcing
>
>
> > Often a little shaking of the pole's guy wires can have
> the desired effect,
> > and has the added advantage of being able to stand far
> enough away so that
> > if anything should fall, it is unlikely to hit you.
>
> Careful now about shaking guy wires. A sledge hammer is
> actually much safer. A hard hammer tap won't hurt a thing. A
> good guyline shake might cause a big problem.
>
> Just the slightest movement will break up the noise, so a
> violent shake is not required.
>
>
>
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi
>
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|