Power comes directly from the battery. The radio is under the right rear
seat; I use an automotive 12V relay, with the coil powered by the ignition
switch, to turn the radio on/off.
To ground the radio, I took out one of the seat bolts, cleaned the paint
from around the hole in the floorboard, and used a ring terminal to attach a
#6 wire.
The stake pocket mounts use star washers to cut thru the paint to ground the
mount (liberal amounts of grease keep away rust). (There is a hole in the
bottom of the stake pocket that the bolt/star washer goes thru to lock down
the Geotools mount.) The shield of the coax connects to the Geotools mount
and is grounded to the truck via the bolt/star washer.
I do have ferrite cores stacked on the coax as it comes out of the stake
pocket, but none on the power to the radio. The power wire from the battery
runs down the right side of the passenger compartment in the cable tray.
I did not run a ground wire from the radio to the battery. I used the same
installation method as land mobile trunk mount radios have used for a couple
of decades (A+ to the battery and ground from a screw located very close to
the radio's chassis.)
One cautionary note: the Tundra was completely redesigned for 2007; I've
never paid any attention to the Sequoia, but I would suspect that it was
redesigned for 2007 as well since they share so many components. Problems
that may have existed in a 2006 or earlier model may not exist in the 2007
or later models.
Doug
K4AC
> -----Original Message-----
> From: rfi-bounces@contesting.com [mailto:rfi-bounces@contesting.com] On
> Behalf Of Jim Brown
> Sent: Thursday, June 11, 2009 11:31 AM
> To: rfi@contesting.com
> Subject: Re: [RFI] Latest RFI-proof SUVs
>
> On Thu, 11 Jun 2009 11:19:15 -0400, Doug Rehman wrote:
>
> >I have a 2008 Toyota Tundra (pickup twin of Sequoia SUV) and haven't
> >experienced any issues in 18 months/18K miles. I run HF-UHF with a
> Kenwood
> >TS-2000/RC-2000.
>
> That's great news, Doug. Where/how do you get power for the radio? Any
> filtering or decoupling on the power? Where is the coax shield
> connected on
> the antenna end? Is the radio chassis connected to anything?
>
> 73,
>
> Jim K9YC
>
>
> _______________________________________________
> RFI mailing list
> RFI@contesting.com
> http://lists.contesting.com/mailman/listinfo/rfi
_______________________________________________
RFI mailing list
RFI@contesting.com
http://lists.contesting.com/mailman/listinfo/rfi
|