----- Original Message -----
From: "Lars Nordgren" <lars.nordgren@fro.se>
> Send own call: Works fine in the call field. But when
> I work a worked station in a new band, I have to look out.
When in S&P mode, the rule is simple :-)
When you're in the Callsign field, Enter sends your call.
When you're in the Exchange field, Enter sends your call,
but only if the exchange is blank - otherwise SD thinks
you have entered the exchange and are now ready to send
your exchange.
The problem arises because SD pre-fills VE provinces
and the state/province of any station worked previously.
This is a clear conflict that I can't resolve. The
solution is to use F5, when appropriate, to send your
call.
> I use an ASUS netbook. While the KB is so small I have
> tried an extra USB-KB.
All USB leads used while transmitting should have an
integrated RF choke. I had a similar RF problem with
WinKey until I changed the USB lead.
73,
Paul EI5DI
_______________________________________________
SD-User mailing list
SD-User@contesting.com
http://lists.contesting.com/mailman/listinfo/sd-user
|