TenTec
[Top] [All Lists]

[TenTec] Remote Pegasus

To: <tentec@contesting.com>
Subject: [TenTec] Remote Pegasus
From: mark@microenh.com (Mark Erbaugh)
Date: Wed, 10 Apr 2002 12:07:22 -0400
Bill,

Thanks for the suggestion.  However, the Pegasus does not have a line level
input. The input level on the ACCY jack is actually the same as for the Mic
input.  Would it be good to boost the mic to line level at the mic end and
then reduce it back to mic level at the Pegasus end?

73,
Mark

----- Original Message -----
From: "Bill Ames" <bames@aob.com>
To: "Mark Erbaugh" <mark@microenh.com>; <tentec@contesting.com>
Sent: Wednesday, April 10, 2002 11:39 AM
Subject: RE: [TenTec] Remote Pegasus


> I would suggest that you use a mixer or some such device at the remote end
> and then you can have a line level signal to feed to the line input. I
think
> you will have problems with long runs of the low level mic signals.
>
> Bill Ames
> KB1LG
>
> -----Original Message-----
> From: tentec-admin@contesting.com [mailto:tentec-admin@contesting.com]On
> Behalf Of Mark Erbaugh
> Sent: Wednesday, April 10, 2002 11:24 AM
> To: tentec@contesting.com
> Subject: [TenTec] Remote Pegasus
>
>
> I would appreciate comments from anyone who has operated their Pegasus
from
> a distance.  I'm considering trying to run my Pegasus in my basement shack
> (where the power, antenna and ground connections are) from the comfort my
> home office on the first floor above where it's not so dark and damp <g>.
>
> I figure the run will be around the 25 foot limit for RS232 (although I've
> seen it go much further), so I don't see a problem for the computer
control.
> I also don't think that there will be a problem with the keyer input. I
have
> some 20 foot mini stereo extension cables that should work for that. I'm
> mostly concerned with the audio both to and from. I don't run QRO and have
> never had a problem with RF, but with 25 feet of audio cabling, I may be
> asking for trouble. Does anyone have a source for long 5 pin DIN to 5 pin
> DIN cables suitable for the ACCY jack?
>
> 73,
> Mark
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>


<Prev in Thread] Current Thread [Next in Thread>