TenTec
[Top] [All Lists]

[TenTec] Pwr Amplifier Titan II

To: <tentec@contesting.com>
Subject: [TenTec] Pwr Amplifier Titan II
From: n4lq@iglou.com (n4lq@iglou.com)
Date: Fri, 12 Apr 2002 07:23:56 -0400
Alfred
I happen to own a TS-870 and use it with a TT Hercules amp in QSK mode. 
My amp's relay system is probably very similar to that of the Titan's. 
For QSK, I use an external keyer and feed the keyer's output directly to 
the amplifier's "key in" jack. Then I run a cable from the amp's "key 
out" jack to the key input of the 870. Due to the delay of the amp's 
relay, I add some weight to the keyer and it works perfectly. If you use 
the sidetone in the rig, you will experience a slight delay due to keying 
system in the amp which takes a few minutes to get used to. One could 
listen to the keyer's sidetone instead.  73
Steve N4LQ

-----Original Message-----
From: alfred.heyden@t-online.de (Alfred Heyden)
To: "TenTec List" <tentec@contesting.com>
To: <tentec@contesting.com>
Date: Fri, 12 Apr 2002 09:34:15 +0200
Subject: [TenTec] Pwr Amplifier Titan II

> Hello dear TT-fellows,
> regards to you all from nr Bonn/Germany.
> One of my fellows is very impressed
> regarding the Titan II.
> He is using the Kenwood TS870 and would
> like to know if
> there is anyone who has an experience
> about this two units
> and how they play together specially in
> cw-qsk. Are there
> some special points of interest what is
> important to know
> before going on air with this equipment?
> A lot of thanks in advance for your
> effort.
> 73's, Alfred, DL2JR
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
> 


<Prev in Thread] Current Thread [Next in Thread>