TenTec
[Top] [All Lists]

[TenTec] Corsair II f.p. meter continued + other fixes

To: <tentec@contesting.com>
Subject: [TenTec] Corsair II f.p. meter continued + other fixes
From: ve1adh@yahoo.ca (David McClafferty)
Date: Fri Jul 4 09:42:17 2003
There are folks out there that rub WD40 on their
bodies for arthritis.
It did attack the plastic. The PTO by the way (which
was replaced with a used spare) ended up in my junk
box. I have used parts to repair others one of which
was dropped on the knob and the shaft pushed the
plastic bushing out of the back. Another one was so
worn that vernier spring pushed the knob right out on
the owners desk.

73, Dave,VE1ADH

 --- Tom North <tomnorth@airmail.net> wrote: > WD40
DOES react with brass, in varying degrees,
> depending on the alloy. Of
> greater concern, if I am to read this that someone
> has used the WD40 in an
> attempt to flush an assembled PTO, is that the
> solvents in it will raise
> Cain with the plastics, and it will not be
> immediately evident.
> Specifically, some of the constituents will cause
> many plastics to brittle
> in (not too long a) time. This would have the most
> direct effect on the
> pistol, and likely with the retainer washer, wedge
> etc. simply crumbling
> under compression. Having done several of these,
> best I see it is that there
> is no short route to doing it the way TT recommends.
> Best luck & 73'
> Tom  N5OZQ
> 
> Original Post:
> A friend of mine sprayed the PTO in his OMNI C with
> WD40. I worked great for awhile and then quit
> altogether. When he brought it to me I took it apart
> and found it was full of fuzzy green stuff that
> apparently came from a reaction between the WD40 and
> the brass parts. Another friend who is in the
> Canadian
> Navy says they have been told not to use WD40 on
> anything brass.
> 
> Dave, VE1ADH
> 
>  --- Gary Hoffman <ghoffman@spacetech.com> wrote: >
> Rob,
> >
> > I'll be very anxious to know how your PTO lube job
> > works out.  I'd like a
> > process that would allow me to avoid a disassembly
> > and rebuild.... just
> <SNIP>
> 
> 
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 

______________________________________________________________________ 
Post your free ad now! http://personals.yahoo.ca
<Prev in Thread] Current Thread [Next in Thread>