TenTec
[Top] [All Lists]

Re: [TenTec] Omni 6/425 Titan - Losing receive audio

To: "tentec@contesting.com" <tentec@contesting.com>
Subject: Re: [TenTec] Omni 6/425 Titan - Losing receive audio
From: "Jim Brown" <jim@audiosystemsgroup.com>
Reply-to: Jim Brown <jim@audiosystemsgroup.com>,tentec@contesting.com
Date: Sun, 12 Dec 2004 21:23:40 -0600
List-post: <mailto:tentec@contesting.com>
On Sun, 12 Dec 2004 17:25:23 -0600, Jay Schwisow wrote:

>However, after another 30 minutes of operation I lost the receive again.  I 
>am thinking I am having intermittent relay problems on the Titan.  Any 
>thoughts?

When this happened to my Titan (in the last hour of a CW contest) it was the 
main antenna relay (on a board right next to the output coax connector). DO NOT 
buy one from TenTec -- bloody expensive, and you can buy good condition used 
pulls on the net for under $40. I bought two so I would have a spare.  It takes 
an 
hour or two to change it is the original Jennings relay. TenTec later switched 
to a 
KiloVac relay, which requires a different PC board -- if you have that one, you 
may need to buy one of the older boards from TenTec. And if you buy the relay 
from TenTec, you'll get both the relay and the new board. $300. 

Here's where I bought mine. I see that they also sell Kilovac, so they may have 
replacements for the newer relay too.  

http://www.mgs4u.com/RF-Microwave/vacuum-relays-SPDT.htm

Another hint. Relay failure can cause transistor failures on another board that 
is 
under the tube sockets (easy to reach from underneath).  Don't run the amp with 
the defective relay to avoid blowing those transistors. The replacement 
transistors should be easy to find. I had exact replacements in my junkbox. 

Jim Brown K9YC


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>