TenTec
[Top] [All Lists]

Re: [TenTec] SDR done right?

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] SDR done right?
From: "Steve Baron - KB3MM" <SteveBaron@StarLinX.com>
Reply-to: Steve Baron - KB3MM <SteveBaron@StarLinX.com>,Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 20 Jun 2005 18:20:47 -0000
List-post: <mailto:tentec@contesting.com>
wORKS FINE HERE TOO. oUR RIGS ARE JUST ABOUT THE SAME DATE.
----- Original Message ----- 
From: "Henry Pfizenmayer" <pfizenmayer@worldnet.att.net>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Tuesday, June 21, 2005 21:36
Subject: Re: [TenTec] SDR done right?


> ????? the auto notch works like a charm on my Feb 2005 Orion with 1.372
> software (AN)
>
> Hank K7HP
>
>
> > My neighbor Pat, K4BEH, had one for a few weeks and he loved it *except*
> > for
> > the lack of autonotch in the DSP. Apparently there was no interest at TT
> > to
> > add the capability via firmware upgrade, so he traded it back in and got
a
> > Jupiter. He agonized quite a bit about it, though, 'cause he REALLY
liked
> > it
> > otherwise.
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>