TenTec
[Top] [All Lists]

Re: [TenTec] Orion Shaft Encoder Replacement

To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Subject: Re: [TenTec] Orion Shaft Encoder Replacement
From: "ROBERT CARROLL" <w2wg@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 13 Jul 2006 14:37:17 -0400
List-post: <mailto:tentec@contesting.com>
Great information.  Thanks and thanks for posting it.
Bob W2WG

-----Original Message-----
From: tentec-bounces@contesting.com [mailto:tentec-bounces@contesting.com]
On Behalf Of Rick Williams
Sent: Thursday, July 13, 2006 12:40 PM
To: TenTec List
Subject: Re: [TenTec] Orion Shaft Encoder Replacement

The RIT encoder replacement procedure developed by John KE5C is on my
website.  Enter the site and it's in the section "Ten-Tec Information".

73, 

Rick 
VE7TK

Website:  http://www3.telus.net/ve7tk  

-----------
Date: Thu, 13 Jul 2006 10:48:35 -0400
From: "ROBERT CARROLL" <w2wg@comcast.net>
Subject: [TenTec] Orion Shaft Encoder Replacement
To: "'Discussion of Ten-Tec Equipment'" <tentec@contesting.com>
Message-ID: <07d801c6a68b$6b9f1310$6401a8c0@D79s9d51>
Content-Type: text/plain;       charset="US-ASCII"

The RIT encoder on my Orion I has failed and the factory is sending me a new
one.  The front panel has to be "completely disassembled" to install the new
encoder.  The meaning of this may be clear when I open up the Orion, but I
would appreciate general or specific guidance from anyone who has done this
before starting.  Is the procedure documented somewhere?  If you know of any
be carefuls and make sure you don't do somethings I would appreciate those
as well.

 

Bob W2WG


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec


_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>