TenTec
[Top] [All Lists]

Re: [TenTec] "End of an Era"

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] "End of an Era"
From: Tod Glenn <n7wd@cordite.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 20 Aug 2006 13:42:28 -0600
List-post: <mailto:tentec@contesting.com>
On Aug 20, 2006, at 5:39 AM, Charles Greene wrote:

> Hi All,
>
> Back in the early 70s, I sold all my tube rigs and went solid state
> with a Ten Tec 940 Triton IV and I vowed never to have tube rigs in
> the shack again.  This is still true except for a couple of linear
> amps.  Now I am contemplating to do the same with analog rigs of
> which I have several including the Omni-VI, and go to software
> defined radios.  This would apply to the shack, as analog rigs still
> have a place in portable and mobile operation.  I still have the 940
> and would probably keep it as a back up.  I plan to wait until Flex
> Radio comes out with there their top of the line software defined
> radio, designed to compete with the Orion, Yaesu FT1K and ICOM
> IC7800.  I have the SDR-1000 and it keeps getting better all the
> time, but there are still some hardware limitations that the
> developers have not come up with software work-arounds for.


I think the point was well made that since SDR depend on computers  
you might be inviting problems.  Unless you plan to buy a new SDR  
every few years, it very likely that as the OS changes, that the  
software might not be updated.  You can still use a non-SDR radio  
made 20+ years ago.  I doubt that will be the case with SDR.

----
Tod Glenn
N7WD
NAQCC #1283
SKCC #1444
FISTS #12134
ARCI #12420
n7wd@cordite.com



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>