TenTec
[Top] [All Lists]

Re: [TenTec] Omni VI serial control

To: Duane Calvin <ac5aa1@gmail.com>
Subject: Re: [TenTec] Omni VI serial control
From: Tod Glenn <n7wd@cordite.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 15 Jan 2007 22:44:20 -0700
List-post: <mailto:tentec@contesting.com>
On Jan 15, 2007, at 10:10 PM, Duane Calvin wrote:

> Hi Tod,
>       I used the two-wire CI-V interface you're referring to.  Be sure you
> have your virtual com port set for the same speed the Omni VI is  
> set for.
> I'm not sure how to set that.  So, you have the USB to serial  
> adapter, and
> what CI-V converter are you using?  I used a homebrew one  
> (described in QST
> back in the 90's) and it worked very well.  But the serial port  
> must be set
> for the same speed as the Omni.  Not sure what else you might  
> check . . .
>
>       73, Duane
>


I'm using a usb to serial that uses the Prolific 2303 chip.  As  
noted, this works fine with Icom 703/706 but not with the Omni.

Serial speed matches, 9600 8N1.  Serial speed on the Omni is set  
using the lock key and option 2.  The plug from the adapter is a 3.5  
mono.  I've never actually seen the plug for the Icom CT-17

Thanks for the help.
----
Tod Glenn
N7WD
SKCC #1444
ARCI #12420
FISTS #12134
NAQCC #1283

n7wd@cordite.com




_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>