Correct me if I'm wrong, but I've always thought of the V.9 and V.92 as
firmware, not software. And it sounds like the display problem is hardware.
73, Mike K9MI
----- Original Message -----
From: "Rick Denney" <rick@rickdenney.com>
To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Sent: Monday, July 30, 2007 18:04
Subject: Re: [TenTec] Frozen display on Omni V.9
> Bob McGraw - K4TAX writes...
>
>> Could this be one of those "3rd party" software glitches?
>
> Could be, but not likely. The N4PY software has been in use on Omni
> V's for quite a number of years, and I've found nothing in the various
> archives linking lockup issues to that software.
>
> I have, however, found a few references in the archives linking
> glitches requiring reset to the original software.
>
> I was doing the research leading up to the purchase (two weeks ago) of
> a V.9 rig, which turned out to be Rick Williams's former rig. I have
> too little experience to speak from that, and can only relate what has
> appeared in the archives.
>
> Rick, KR9D
>
> ---
> Richard W. Denney, Jr. PE|Iteris, Inc. |
> Associate Vice President |107 Carpenter Dr. Ste 230 | 703.925.3819
> rwd@iteris.com |Sterling, VA 20164 |Fax 703.471.1757
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|