TenTec
[Top] [All Lists]

Re: [TenTec] 962 Power supply Bridge rectifier needed

To: <geraldj@storm.weather.net>,"Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] 962 Power supply Bridge rectifier needed
From: "Phil Chambley Sr." <k4dpk@comcast.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Tue, 1 Jan 2008 22:22:19 -0500
List-post: <mailto:tentec@contesting.com>
I must be thinking about a different T/T power supply, since I have worked 
on quite a number.

Tell you what, I'll just with-hold my comments and that way you fellows can 
solve these problems without my interference.

73
Phil Chambley, Sr.
k4dpk


----- Original Message ----- 
From: "Dr. Gerald N. Johnson" <geraldj@storm.weather.net>
To: <tentec@contesting.com>
Sent: Tuesday, January 01, 2008 9:28 PM
Subject: Re: [TenTec] 962 Power supply Bridge rectifier needed


> On Tue, 2008-01-01 at 20:20 -0600, Bob McGraw - K4TAX wrote:
>> How about this:   GBPC3501  $2.92 in single lot qty.  From Mouser
>>
>> Manufacturer data sheet:  http://www.fairchildsemi.com/ds/GB/GBPC3501.pdf
>>
>> 35amp, 100 PRV.   It is a real generic non-critical part.  Now what's
>> critical is to clean the bottom of the power supply where the bridge 
>> block
>> mounts, make sure you have some good heat sink compound but not too much 
>> and
>> bolt the sucker in tight with the center mounting screw.    If you 
>> choose,
>> use the crimp on spade lugs but do solder the wires to the female spade
>> terminals.  When pushing the lugs on, make sure they are tight and snug.
>> Otherwise if you have a suitable soldering iron, solder the wires direct 
>> to
>> the bridge block.
>>
>> 73
>> Bob, K4TAX
>>
> Now he says it plugs into the PC board and the NTE lugs don't line up
> with the slots in the board. In the NTE catalog I see two post
> arrangements and one with round wires. I can't tell from here which
> fits.
>
> 73, Jerry, K0CQ
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec 

_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>