TenTec
[Top] [All Lists]

Re: [TenTec] Bazooka antenna.. More than you wanted to know!

To: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Subject: Re: [TenTec] Bazooka antenna.. More than you wanted to know!
From: Steve Hunt <steve@karinya.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Mon, 02 Jun 2008 23:31:10 +0100
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
Jerry,

Very interesting stuff! I had not looked at your "parallel-tuned-circuit 
in parallel" option before; I just modelled it in EZNEC to learn more 
and saw some interesting results.

I took a dipole constructed of 128ft of #14 copper wire. It resonated in 
Free Space at 3.745MHz, where it exhibited a resistance of 74 Ohms. It 
had a 2:1 VSWR bandwidth of 150KHz.

Then I looked to see how the Susceptance changed for a small frequency 
shift, and calculated the component values you would need in the 
parallel tuned circuit to compensate. I was surprised how big a C was 
needed (5,730pF) and how small the L (0.315uH). I tried that combination 
in EZNEC and the VSWR bandwidth improved to 185KHz. What was interesting 
was that, although the reactive element was being compensated quite 
accurately, the presence of the tuned circuit caused the 
series-equivalent Resistance to vary more quickly with frequency than in 
the un-compensated case. So the bandwidth improvement was not as great 
as I'd expected.

Next I tried your 2000pF figure and the 3m (lossless) stub. It didn't do 
quite as well as my values, so I doubled the capacitance and shortened 
the stub to compensate. The bandwidth was then back up to 185KHz.

Here's the interesting bit ..... only when I started to introduce some 
losses into the stub did the bandwidth increase really significantly. 
Once I put "real world" RG58 loss numbers in, the bandwidth shot up to 
400KHz. But at that point the radiated power was down by 2dB!

Using RG213 loss figures produced a bandwidth of 305KHz and a drop in 
signal of 0.9dB

I guess only individual ops can say whether these losses are prices 
worth paying for the convenience of "tuner-free" operation.

73,
Steve G3TXQ



_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>