I purchased my Orion in August of 2005 from Ten-Tec. In March of 2007 smoke
came out of the Orion, and it was returned to the factory for repair. In
the
invoice, Ten-Tec wrote "Replaced fried 10 volt regulator, resistors,
capacitor on logic board."
In July of 2007 the Orion would not power up, and it again was returned to
the factory. This time Ten-Tec wrote on the invoice "Replaced bad
capacitors
on power distribution board." They also wrote "Checked with customer
regarding possible power supply problem."
It is now late June of 2008, and the Orion is working fine. My power
supply
is an Astron RS-35A, which seems to be working normally. I should mention
that I use an Acom 1000 with my Orion, and before I made some major
antenna
changes I did have a fair amount of rf in the shack.
John, N9JG
= = = ORIGINAL MESSAGE = = =
Date: Tue, 24 Jun 2008 22:19:27 -0700
From: "Ron Castro" <ronc@sonic.net>
Subject: [TenTec] Orion II A9 Board Failure...Again!
To: "Ten Tec List" <tentec@contesting.com>
Message-ID: <DC35B7F9E1AD4AFA8BF7B1C980E9693D@OwnerPC>
Content-Type: text/plain; charset="iso-8859-1"
About 10 months ago, the capacitors on the A9 Power Distribution board
failed, and I sent the radio back to the factory to get it fixed. Well,
just 10 months later, the same thing happened again. This time, I decided
to fix it myself with premium capacitors purchased through Mouser. The
fix
worked! The 470 uf, 16 Volt, 85 degree C caps, C6, C7 and C9 were
replaced
with ultra-low ESR 50 Volt, 105 degree C units that fit perfectly in the
board.
[snip]
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec