TenTec
[Top] [All Lists]

Re: [TenTec] Orion II A9 Board Failure...Again!

To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
Subject: Re: [TenTec] Orion II A9 Board Failure...Again!
From: "Dick Williams" <k8ztt@mho.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 26 Jun 2008 15:40:27 -0600
List-post: <mailto:tentec@contesting.com>
Well, my O II quit right before a contest weekend that I had hoped to pick up a few new ones. Called Ten Tec and upon describing the symptoms, was told it was most likely two capacitors on the power supply borad and they would send me a couple in the mail.

Problem was that I wanted to use the radio; simple answer was to drive to Radio Shack and purchase a couple of 470uf 35WV ones. When I tore into the O II and found the A9 board, it was obvious that one of the caps had failed. Replaced it with the one from Radio Shack and I was back in business.

That was about 4 months ago and though I have received the new ones from Ten Tec, I have not bothered to replace the Radio Shack one or the other "original" one that is prone to failure. If and when one of these fails, I will replace both with the new ones from Ten Tec.

In any case, if there is a Radio Shack near you, there is no need to be down more than drive time plus about 20 mins to replace the bad cap.

Dick K8ZTT


<Prev in Thread] Current Thread [Next in Thread>