TT supplies a great quiet fan that clamps on the fins, if one is to operate
for longer times, ie: FD or Contest work. One would be FOOLISH not to use
one.
Lyle
----- Original Message -----
From: "Gary Hoffman" <ghoffman@spacetech.com>
To: <ken.d.brown@hawaiiantel.net>; "Discussion of Ten-Tec Equipment"
<tentec@contesting.com>
Sent: Wednesday, July 09, 2008 11:48 AM
Subject: Re: [TenTec] Bliss: Omni 546C working FB again
> It may depend on the physical layout of the heat sources.
>
> If they are concentrated in a few small areas, then a long, horizontal fin
> may more effectively spread the heat into a lot more fin area.
>
> If that is not the case, vertical would have been better.
>
> But I'd bet you they do it for the reason I mention.
>
> 73 de Gary, AA2IZ
>
>
> ----- Original Message -----
> From: "Ken Brown" <ken.d.brown@hawaiiantel.net>
> To: "Discussion of Ten-Tec Equipment" <tentec@contesting.com>
> Sent: Wednesday, July 09, 2008 12:51 AM
> Subject: Re: [TenTec] Bliss: Omni 546C working FB again
>
>
>>
>>
>> > I had intended to replace the heatsink with one that has the fins
> vertical oriented (and
>> > hence increasing the cooling capacity) and had it already drilled and
> ready to go in.
>> >
>> >
>> I have always wondered why Ten-Tec has the heat sink fins horizontal on
>> the Omni VI and Paragons. I wonder , have they done this on all of
>> their transceivers? The 961 and 962 power supplies have the fins
>> vertically oriented which, as far as I know, is the right way.
>>
>> DE N6KB
>>
>> _______________________________________________
>> TenTec mailing list
>> TenTec@contesting.com
>> http://lists.contesting.com/mailman/listinfo/tentec
>>
>
>
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
>
>
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|