Pete,
I'd say the 705 desk mic or the 701 hand mic would fit the bill. I believe
both of these were current at that time. I had a 701 for a long time and
finally sold it. I still have a 705 and use it from time to time. As I
recall, I used a 705 desk mic on an old Omni C and it worked fine. Had to
use a battery in the mic to power up the electret. This mic was recommended
by TT for use on that old rig. Used it on a Corsair and then also on an
Omni V and now on an Omni VI+. I believe the two mic's mentioned fit the
time frame of the rigs you mentioned.
David
Wd9cmd
----- Original Message -----
From: <dypete@aol.com>
To: <tentec@mailmain.qth.net>; <tentec@yahoogroups.com>;
<tentec@contesting.com>
Sent: Saturday, May 30, 2009 2:40 PM
Subject: [TenTec] Desk Microphones for Delta II,Argonaut II and V and the
"6N2"
Hello all and thank you for reading my post (again!)
?
Almost there!!!
?
Looking for any desk top?Ten-Tec microphones that were used with the Delta
II, Argonaut II and V and the "6N2" transceivers. Not the hand held
microphones.?The 708 is not made for those units. Microphones made 10-20
years ago specific for those units
?
Please advise on condition (electronically and cosmetically) and price.
Please reply direct and not to the reflector.
?
Tnx again for every ones help!
?
73!
Pete
KB2DY
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec
|