TenTec
[Top] [All Lists]

Re: [TenTec] Paragon - easy to work on?

To: tentec@contesting.com
Subject: Re: [TenTec] Paragon - easy to work on?
From: Ben Hall <kd5byb@kd5byb.net>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Thu, 27 May 2010 07:23:39 -0500
List-post: <mailto:tentec@contesting.com>
On 5/26/2010 10:13 PM, Bwana Bob wrote:
The front panel is on hinges. Take off the top and bottom covers.  There
will be a screw on each side of the front panel. Remove these 2 screws
and the panel will swing down, giving you access to the pots. Be careful
not to put any strain on the potentiometer leads, or the phenolic on the
back of the pot will break.

Hi Bob,

THANKS MUCH for posting this! Last night I was able to get a little Deoxit into the RF gain pot but was really struggling with how I was going to access the other pots. This will make it much easier and I really appreciate it!

thanks much and 73,
ben, kd5byb
--
Ben Hall, kd5byb@kd5byb.net - ALWAYS OUTNUMBERED, NEVER OUTGUNNED.

<Prev in Thread] Current Thread [Next in Thread>