TenTec
[Top] [All Lists]

Re: [TenTec] 255 Power Supply

To: Ten Tec <tentec@contesting.com>
Subject: Re: [TenTec] 255 Power Supply
From: James Duffer <dufferjames@hotmail.com>
Reply-to: Discussion of Ten-Tec Equipment <tentec@contesting.com>
Date: Sun, 13 Mar 2011 13:07:20 -0500
List-post: <tentec@contesting.com">mailto:tentec@contesting.com>
I don't know what kind of multimeter you have, but all meters do not have the 
red lead positive when in the Ohms position.  When checking fwd and rev 
resistance of semiconductor junctions it becomes a factor.

73, Jim  wd4air

> Date: Sun, 13 Mar 2011 10:02:59 -0700
> From: ural.jim@gmail.com
> To: tentec@contesting.com
> Subject: Re: [TenTec] 255 Power Supply
> 
> Is there a way to check the SCR? I pulled the board this morning and upon
> closer inspection it is discolored at the base where the leads emerge.
> 
> I ordered a couple of the transistors from Mouser and will add the SCR to
> the order.
> 
> Jim
> K6JEA
> On Sun, Mar 13, 2011 at 9:08 AM, Dr. Gerald N. Johnson
> <geraldj@weather.net>wrote:
> 
> > The transistors are wired in parallel, but that 0 resistance from base
> > to one of the connections is a shorted junction in one of them. There's
> > no repair possible for the transistor, it must be replaced. When you
> > take them out, you can tell which is bad, but a sturdy pair isn't a bad
> > investment.
> >
> > .514 is about right for the forward drop of a silicon junction. OL is
> > right for open. Which a junction should be one way. .000 for both
> > polarities of the meter shows the shorted junction.
> >
> > 73, Jerry, K0CQ
> >
> > On 3/12/2011 10:23 PM, Jim Anderson wrote:
> > > After searching Google on how to test a transistor I realized I was doing
> > it
> > > wrong.
> > >
> > > Here are the new readings...
> > >
> > > On the Diode function and the black lead on the base it reads .514 on one
> > > terminal and .000 on the other
> > > With the red lead on the base it reads OL on one terminal and .000 on the
> > > other.
> > > Both transistors give the same results.
> > >
> > > On the 2K ohm scale with the red lead on the base it reads 1.2 on one
> > > terminal and .000 on the other
> > > With the black lead on the base it reads 1.1 on one terminal and .000 on
> > the
> > > other.
> > > Again, both transistors give the same results.
> > >
> > > Thanks for sticking with me on this.
> > >
> > > Jim
> > >
> > >
> > _______________________________________________
> > TenTec mailing list
> > TenTec@contesting.com
> > http://lists.contesting.com/mailman/listinfo/tentec
> >
> _______________________________________________
> TenTec mailing list
> TenTec@contesting.com
> http://lists.contesting.com/mailman/listinfo/tentec
                                          
_______________________________________________
TenTec mailing list
TenTec@contesting.com
http://lists.contesting.com/mailman/listinfo/tentec

<Prev in Thread] Current Thread [Next in Thread>